Automatic Membrane Filter Press For Wastewater Treatment 0.8Mpa

Hot Sale ZR250-1250 Automatic Membrane Filter Press

Technical Parameters

Model: ZR250-1250

Filter area: 250m2

Filter plate size: 1250*1250mm2

Filter cake thickness: 30mm

Filter room volume: 3729L

Menber filter plate quantity: 47pcs

Chamber filter plate quantity: 46pcs

Motor power: 5.5kw

Filter pressure: 0.8Mpa

Technical Parameter Of ZR Serial

Profile
During operation, when the feed is finished, the high-pressure fluid medium can be injected into the diaphragm plate, then the whole diaphragm will bulge up and press the filter cake so as to achieve the further dehydration of the filter cake, that is, press filtration.
Apply to sludge, sewage treatment. The minimum moisture content of the filter cake has been less than 60%. Compared with the traditional box-type filter press, The highest solid content of the filter cake can be increased by more than 2 times as much as that of the traditional filter press.
The transportation cost of filter cake has been greatly reduced. Filter cakes can be fired directly into the power plant, turning the sludge into a resource and sewage into a spring, completely replacing the box filter press.

Working Principle Of Chamber Filter Press

1. Slurry is pumped into the filter press. The solids are distributed evenly on the filter cloths during the feed (fill) cycle.
2. Solids begin to build on the filter cloth, trapping the ensuing particles and building a filter cake. The filter cake acts as a depth filter for solid/liquid separation. Filtrate exits the plates through the corner ports into the manifold.
3. When the correct valves in the manifold are open, the filtrate exits the press through the filtrate outlet. As the filter press feed pump builds pressure, the solids build within the chambers until they are completely full of filter cake.
4. Once the chambers are full, the fill cycle is complete and the filter press is ready to be emptied.

Scope Of Application

​​

​​